Deluxe Beer Cleaning Kit Instructions

Step 1

Take your tap and place in a clean bucket in the open position. If you have a homebrew/soda system, connect your liquid line out to a empty keg and open the closure hatch.

Note: Some taps, not all, are equipped with a check valve in the beer out connection. Insert your ball holder into the bottom of the tap to keep this in the open position while flushing.

Step 2

Remove the faucet from your shank. Dismantle your faucet completely and soak the part in the recommended concentration of the cleaning solution. The faucet wrench will help loosen the coupling nut. The coupling nut will have holes for the wrench to grab with the pin at the end of it's curved cradle.

Step 3

While soaking these parts run the large end of brush though the entire faucet body to loosen any soil. Then continue soaking the faucet body. Use the small end of the brush to loosen any soil through the length of the shank.

Step 4

Fill your pump station jar with the recommended concentration of the cleaning solution and connect the fitting on the hose to the shank that you removed the faucet from. Pump the solution through the shank, line and tap followed by two full jars of water.
(Always hold the pump body while pumping to prevent undue stress on the jars lid)

Step5

Rinse and reassemble your faucet lubricating your o-rings and washers and return it to the shank. Use the faucet wrench to tighten the faucet. Don not over tighten the coupling nut. This could damage the o-ring that makes the seal.